EWRF-e7082TM 5.8G 48CH 25/100/200mW Switchable Transmitter support PWM/OSD Configuring - Heise
EWRF-e7082TM 5.8G 48CH 25/100/200mW Switchable Transmitter support PWM/OSD Configuring
Adjustable 4 modes:25mW/100mW/200mW/OFF
700VTL camera, 120degree field of view
Betaflight/Cleanflight OSD setting of power,bands,channels and PitMode
Clean powerup and channel switching without interference to others
PWM channel changes and PitMode setting
Support external OSD and NTSC/PAL switch
Miniature and light weight design
Model: EWRF 7082VTA1S
Frequency: 5.8G 48CH
Power supply:DC 6-25V(1S)
Resolution:PAL 720x540/NTSC 640x480
Angle of view: H 120 degree, V 110 degree
Antenna: Exclusive Dipole Whip
After power on, the digital display shows the following three parameters in turn: channel, band and power.Press and hold the button until the red dot appears on the right bottom of the digital display, which can be entered into the parameters setting.
When the digital display shows the Arabic numerals for the channel (1-8),press the button can select the channels.
Press and hold the button again,the digital display will shows the alphabet for band(A-b-c-d-E-F), press the button can select the bands.
Press and hold the button again,the digital display will shows the indication for power(H:200mW,U:100mWmL:25mW,OFF), press the button can select the power.
Finally, press and hold the button,the red dot on the right bottom of the digital display will disappear.VTX is back to normal working state and the channel,band,power will display in turn on the digital display.
2. PWM/OSD setting
When PWM port is connected with a RC receiver, it can been used to change AV channels 1-8 and to shut transmitting by a RC( PITMODE in effect). Make sure that there is a PWM signal from receiver within 3 seconds after powering up ,otherwise the transmitter is back to button-press setting mode . When in the setting mode of PWM, the red dot on the digital display will glow.
For Betaflight/Cleanflight OSD setting of power,bands,channels and Pitmode ,please referring to EWRF 5.8G AV TX OSD Setting for details.
Note: 1.Make sure that there is enough space for airflow when installing the module on the drone in case the overheating protection starts to reduce the power even to shut down at the worst.
2. Please install the antenna before powering up for a longer use life.
3. .The maximum current of output DC 5V is 300mA.
|Dimension and Weight||
No reviews yet!
FullSpeed Amass XT30 Current Sensor - Yellow$9.71
Ultraligh Portable Travel Hammock - Multi-d - 270*140CM$16.89
Carbon Fiber 5332 Quick Release Propellers for DJI MAVIC AIR Drone 2 Pair - Black$18.86
5332S Propellers Carbon Fiber Quick Release Props for DJI MAVIC AIR Drone 1 Pair - Black$11.13
New Heightened Landing Gears Stabilizers Extensions for DJI MAVIC AIR - Black$12.89
FullSpeed 0703 15000KV 1S Brushless Motor - Blue Eyes$15.44